MV Motorrad / エムブイ モトラッド RAM-XGRIP Holder for Smart Phones and Other Mobile Phones - Ram-XGRIP
XGRIP Holder for Smart Phones and Other Mobile Phones
The stainless XGRIP holder offers a quick solution to place your mobile phone on the handlebar or on an M8 thread and then use it as a navigation system.
The soft rubber blocks of the XGRIP holder almost stick to the device and thus ensure a truly safe hold.
You also can use them on a the handlebar of a bicycle.
Ram-XGRIP1 is for smart phones / mobile phones with a width of 40 to 80 mm wide.
And the variants RAM-XGRIP2 for 60 to 100 mm smartphones / mobile phones and RAM-XGRIP3 fĂĽr 90 - 140mm smartphones / mobile phones. They can be used up or broad.
Both are equipped with a 25 mm RAM ball.
To fitting and securing on the handlebar, we recommend our article no. 10222 for 22-25-28 or 32 mm handlebars. Or article no. 10186 for 8 mm thread. Please feel free to ask us.
All balls are provided with a rubber ring and therefore are non-slip and vibration-damped.
To connect both balls, the RamMount holders item no. 109010 or 109011 are required.
You will find further adapters for fixing your mobile on your motorbike on our website or please do feel free to contact us.
Your next smartphone (in your car or on your bicycle) will probably also fit in this kind of holder. Not necessarily for hard offroad use.
PLEASE NOTE:A problem might occur when the control buttons are at the place where the rubber flanges pressing to the casing. It depends on the width of the device.